Waeco SinePower SP700 Instrucciones De Uso página 30

_MSK.book Seite 30 Montag, 26. Februar 2007 10:15 10
Connecting the inverter
7.3 Mounting the inverter
➤ Hold the inverter against the installation location and mark the fastening
points (3 A, page 3).
➤ Fasten the inverter using your chosen method (3 B, page 3).
8 Connecting the inverter
8.1 General instructions
Warning
Never use the inverter on vehicles where the positive terminal of
the battery is connected to the chassis.
When installed in vehicles or boats, the inverter must be connected to the
chassis or earth.
When setting up a socket distribution circuit (mains setup), comply with
VDE 0100.
Only use copper cables.
Keep the cables as short as possible.
Keep to the specified cable cross section and fit a cable fuse (2 1,
page 3) as close to the battery as possible on the positive cable (see the
table).
Warning
If you do not fit a fuse in the positive cable, the cables may be
overloaded, which might result in a fire.
30
SinePower