Factory Reset - Pentair VS2 Guia De Instalacion

15

Factory Reset

The drive can be reset to factory settings if necessary. A
Factory Reset will wipe out all of the saved user settings that
have been programmed, except for the time of day. Be sure
that it is necessary before performing a Factory Reset, as the
results are immediate.
To perform a Factory Reset:
1. Stop the pump if necessary by pressing the Start/
Stop button.
2. Record all of the custom schedule settings using Table 3.
You can find these setting by pressing the "1", "2", "3",
and "Quick Clean" buttons and cycling through all the
screens. Also write down the Priming Speed.
3. Press and hold the "1", "2", "3", and "Quick Clean"
buttons for 3 seconds.
4. The screen will display "FACt rSt" if factory reset is
successful. See Figure 14.
5. Be sure to reprogram the schedule and priming speed
after the factory reset. The pump must be turned back
on with the Start/Stop button before it will run again.
The pump will run the programmed schedule upon
initial start-up.
Note: Factory Reset can not be performed from a Keypad
Lockout state.
FACt
Figure 14: Drive Factory Reset
Speed
(RPM)
SPEED 1
SPEED 2
SPEED 3
QUICK
CLEAN
Priming
Speed
Table 3: User Programmed Schedules
rSt
Duration Start Time
(Hours) (Time Clock)