Epson FX-890 Manual Del Usuario página 35

1. Make sure the printer is turned on.
2. Load paper. (If the tractor is in a push position, press the Load/Eject
button to advance continuous paper to the current top-of-form
position.) If necessary, lift up the printer cover so you can see the
paper position.
3. Hold down the Pause button for three seconds. The Pause light
flashes and the printer enters the Micro Adjust mode.
4. Press the LF/FF D
button to move
the top-of-form
position up on the
page, or press the
Load/Eject
button to move
the top-of-form
position down on
the page.
5. Press the Pause button to exit the Micro Adjust mode.
Note:
The printer has a minimum and a maximum top-of-form position. If
you try to adjust it beyond these limits, the printer beeps and stops
moving the paper.
When the paper reaches the default top-of-form position, the printer
beeps and stops moving the paper briefly. You can use this setting as a
reference point when adjusting the position.
The top margin setting made in some software overrides the top-of-form
position setting you make with the Micro Adjust function.
U
Paper Handling
33