Changing The Printer's Default Settings - Epson FX-890 Manual Del Usuario

Changing the Printer's Default Settings

While you can often change the printer's settings through your software
or printer driver, you may sometimes need to change one or more of the
printer's default settings. There are two ways to do this:
Using the EPSON Remote Configuration Manager on the printer
software CD-ROM. (See page 15.)
From the printer's control panel using the default-setting mode.
For instructions on using the Remote Configuration Manager, see the
PDF manual on the CD-ROM. To use the control panel, see below. For
detailed information about default settings, see the Reference Guide. The
following table shows the options available for each printer setting.
Setting
Page length for front
tractor
Page length for rear
tractor
Skip over perforation
Auto tear-off
Auto line feed
Print direction
Software
0 slash
I/F (interface) mode
Auto I/F wait time
Parallel I/F bidirectional
mode
Packet mode
Character table
International character
set for italic table
Manual feed wait time
Buzzer
38
Using the Control Panel
Options (default in bold)
Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5, 11, 70/6, 12,
14, 17
Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5, 11, 70/6, 12,
14, 17
Off, On
Off, On
Off, On
Bi-D, Uni-D
ESC/P, IBM PPDS
0,
Auto, Parallel, USB, Option
10 seconds, 30 seconds
Off, On
Auto, Off
Italic, PC 437, PC 850, PC 860, PC 863, PC 865, PC 861,
BRASCII, Abicomp, Roman 8, ISO Latin 1, PC 858,
ISO 8859-15
Italic U.S.A., Italic France, Italic Germany, Italic U.K.,
Italic Denmark 1, Italic Sweden, Italic Italy, Italic Spain 1
1 second, 1.5 seconds, 2 seconds, 3 seconds
Off, On