Adjusting The Top-Of-Form Position - Epson FX-890 Manual Del Usuario

3. Open the paper guide cover, then press the LF/FF D button to feed
paper backward, or press the Load/Eject U button to feed paper
forward, until the paper perforation is aligned with the tear-off edge
of the printer cover.
Note:
The printer has a minimum and a maximum tear-off position. If you try to
adjust the tear-off position beyond these limits, the printer beeps and stops
moving the paper.
4. Tear off the printed pages.
5. Press the Pause button to turn off Micro Adjust mode.
When you resume printing, the printer automatically feeds the paper
back to the top-of-form position and begins printing.

Adjusting the top-of-form position

The top-of-form position is the position on the page where the printer
starts printing. If your printing appears too high or low on the page, you
can use the Micro Adjust function to adjust the top-of-form position, as
described below. Your top-of-form position setting remains in effect until
you change it, even if you turn off the printer.
Caution:
c
Never use the knob to adjust the top-of-form position; this may damage the
printer or cause it to lose the top-of-form position.
32
Paper Handling
Tear-off edge of the printer cover
Paper perforation