Loading Continuous Paper With The Pull Tractor - Epson FX-890 Manual Del Usuario

5. Make sure your paper
has a clean, straight
edge. Then open both
sprocket covers and fit
the first four holes of
the paper, with the
printable side down,
over the tractor pins.
6. Close the sprocket covers. Then slide the right sprocket to remove
any slack in the paper and lock it in place by pushing the blue lock
lever down.
7. Attach the paper guide and lay it flat on the printer. Slide the edge
guides to the middle of the paper guide.
8. Turn on the printer. When the printer receives data, it automatically
loads the paper and starts printing.
If the first line on your page appears too high or low, change its position
with the Micro Adjust function. (See page 32.)
Caution:
c
Never use the knob to adjust the top-of-form position; this may damage the
printer or cause it to lose the top-of-form position.

Loading Continuous Paper with the Pull Tractor

1. Make sure the printer is turned off, and the printer cover is
removed. Also make sure the tractor is installed in the pull position
and the paper guide is lying flat on the printer. (You may need to
move the tractor from the rear push or front push position.)
2. Set the paper release lever to the pull tractor position.
22
Paper Handling