Descargar Imprimir esta página

Etac molift Transfer Pro Manual Del Usuario página 12

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
The device
Always check – before each use:
that the user has the required ability for the
device. If needed use any suitable accesso-
ries.
that the device is suitable for the user and
the transfer situation.
that the device does not have visible dam-
age.
that the wheels on the wheelchair or bed are
locked during the transfer.
that the device is locked when the user is
moving from sitting to standing and vice
versa.
if the inspection reveals any safety risks,
the device must immediately be taken out
of service.
never use a faulty or damaged device as
it can cause personal injury. Contact your
local distributer/representative for further
instructions.
Safety measures
The base plate has visible feet contours and anti-slip surface for extra safety.
The central brake provides auditive feedback and is easily accessible as it locks both wheels by activating
only one of the brake pedals. When activated a red marking becomes visual. The central brake is marked
with a (P) on the device.
The triangular marking on the side of the seat pad must minimum reach the front egde of the seat before
the user sits down. (See illustration no. 02 on page no. 53). If the triangular marking does not reach the
front egde of the seat, the transfer must under no circumstances be completed. If the triangular marking
reaches the front egde of the seat, make a risk assessment to make sure that the user sits down far
enough into the seat.
200cm
149cm
EN
Materials
All used materials which are to be in direct contact
with skin are biologically assessed and evaluated
according to relevant standards. However, users/
carers who are allergic to any of the materials are
recommend not to use the device.
Accessories
User manuals supplied with accessories must
be read and understood before use. This in-
cludes any limitations in use and combinations.
Information about accessories can be found on
www.etac.com.
Spare parts
A list of spare parts is available at www.etac.com.
Combinations
When combining the device with other devices or
accessories, the combination must not change the
intended purpose of the devices or modify the de-
vices in such a way that compliance with the appli-
cable requirements may be affected. The person
/company responsible for the combination of the
devices must ensure that the applicable require-
ments are fulfilled.
Assembly and supplied parts
Consult the assembly guide on www.etac.com.
12
BM70199 Rev. 1.0

Publicidad

loading

Este manual también es adecuado para:

16090300