Mark MDX 0408 Manual Del Usuario página 17

Test signal function:
Click the "Settings" button on the right side of "Test Signal" to pop up the test signal interface.
It is divided into the upper half of the test signal switch setting options and the lower half of the channel
selection test signal options. Configure the three commonly used test signals (sine wave, pink noise, white
noise) to set the switch and gain value, green is open, red is closed. For channel selection, if you select
"sine wave", "pink noise" and "white noise", the open test signal will enter the channel; if it is selected as
an analog signal, it will switch back to analog signal input and turn off the test signal.
Input noise gate:
Double-click in the function button , the following figure input noise gate function interface will
pop up.
16