Mark MDX 0408 Manual Del Usuario página 26

In the above figure, the left side corresponds to the output channel, and the upper side corresponds to
the input channel. The value box with a value is the input and output channel mixing key. When the mixing
key is green (double- click the value box to switch the state), the input channel and output channel signal
realizes the mixing function. The right part of the above figure contains the gain, reset button, and clear
button of the matrix mix. Click the value box on the left, and then drag the sliding block of the matrix mix
gain or enter a value in the value box to adjust the matrix block Click the reset button to reset the matrix
mixing function to the initial one- to- one state; click the clear button to clear all the matrix mixing
functions, and there is no correspondence between the input and output of the device.
Output Parametric Equalizer (PEQ):
Double-click the function button , output equalizer function interface will pop-up shown, the
parameter equalization function and operation mode are the same as input equalizer. But the output has
increased the high and low pass filter function than the input, as described below.
EQ high and low pass filter:
As shown above, high pass or low pass section in the lower right corner as shown in the left
, you can control the switch, frequency and type of high pass and low pass , highest filter type
slope is 48dB
25