Publicidad
Idiomas disponibles
Idiomas disponibles
Click the channels link button
between the input and output channels on the software homepage,
channels link interface will pop up as following figure.
As shown in the figure above, the three lists from left to right are divided into channel list, group list, and
parameter list: The channel list has listed all the channels that can be tuned together. After selecting the
corresponding channel, click the Add button
to move to the group list. After grouping the list of
default four groups, directly select the corresponding packet, if the channel list will be added directly to
the channel assigned to the selected group, to remove the optional channel to be removed by clicking
the Remove button
below to add a button that is can be removed to the channel list. The parameter
list is the parameters that can be adjusted jointly in the grouping list. When the check is ticked, it means
that when the parameters of several channels in the same group are adjusted, other channels will make
the same adjustment at the same time.
Device list:
The device list on the software homepage.
The above figure (1.) shows the connected device numbers, which are automatically arranged in the order
they are scanned; (1.MDX0408) is the device name, which can be changed at will, which is convenient for
management; (0408F) is the factory name (the user cannot modify it); if the connection method is TCP,
the factory name will be left after the connection is connected. The side will display the IP address of the
device; if it is in USB mode, it will display USB; if it is connected in serial port mode, it will display the specific
COM port used.
From left to right, it is divided into mute button, disconnect/connect button,
and remove device button. The mute button can directly control the mute of all output channels of the
28
Publicidad
