Fitting And Removing The Chute; Fitting The Chute; Removing The Chute; Fitting And Removing The Blade - Stihl RMA 510 V Manual De Instrucciones

English
► Open the discharge shield and hold it in position.
► Remove the mulch plug.
► Close the discharge shield.
7.4

Fitting and Removing the Chute

7.4.1

Fitting the Chute

► Switch off the mower, remove the activation key and
battery.
► Place the mower on a flat surface.
1
► Open the side discharge shield (1) and hold it in position.
► Engage hooks (2) on the shaft (4) from below.
► Rest the side discharge shield (1) on the chute (3).
7.4.2

Removing the Chute

► Switch off the mower, remove the activation key and
battery.
► Place the mower on a flat surface.
16
4
3
2
1
► Open the side discharge shield (1) and hold it in position.
► Swing the chute (2) upwards and lift it away.
► Close the side discharge shield (1).
7.5

Fitting and Removing the Blade

7.5.1

Attaching the Blade

► Switch the lawn mower off, pull out the activation key and
remove the battery.
► Upend the lawn mower.
1
2
► Place new washer (1) on new bolt (2).
► Apply Loctite 243 or Loctite 242 thread locker to the
thread of bolt (2).
► Position blade (3) so the raised areas on the contact area
engage in the notches in blade (3).
7 Assembling the Lawn Mower
2
3
0458-819-9921-A