ST AB 500 Li 48 Manual De Instrucciones página 138

Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Quote the information on
the product identification label whenever you
contact an Authorised Service Centre.
IMPORTANT An example of the
Declaration of Conformity is provided
on the last pages of this manual.
3.4 MAIN COMPONENTS
The machine is composed of a series
of main components that have the
following functions (Fig.1 ):
A. Power unit: it drives the rotor.
B. Blower tube: it is the component through
which the air flow is discharged.
C. Handgrip: it makes it possible
to control the machine.
D. Harness (if available): device made
up of a fabric belt which, placed over
the shoulders, helps to support the
weight of the machine during work.
E. Harness connection point (if
available): where the harness is
connected to the machine.
F. Battery (accessory available upon
request, paragraph 14.1): device that
supplies electric current to the tool; its
specifications and regulations for use
are described in a specific manual.
G. Battery charger (accessory available
upon request, paragraph 14.2): device used
to recharge the battery; its specifications
and regulations for use are described in
a specific manual. Two battery charger
models are available: G1 (fast battery
charge); G2 (standard battery charge);.
H. Battery backpack (attachment
on request, par. 14.3): device in
which the batteries are placed.
I. Connection cable: cable used to connect
the machine to the battery backpack.
J. Battery simulator (attachment on
request, par. 14.4): device that, if
inserted in the machine housing, allows
the use of the battery backpack.
4. ASSEMBLY
IMPORTANT The safety regulations to
be followed are described in chap. 2. Strictly
comply with these instructions to avoid
serious risks or hazards.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the
assembly should be done on a flat and
stable surface, with enough space for
machine handling and its packaging,
always making use of suitable equipment.
Do not use the machine until all the
instructions provided in the "ASSEMBLY"
section have been carried out.
4.1 ASSEMBLY COMPONENTS
The packaging includes assembly components.
4.1.1 Unpacking
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
Before assembling, make sure the
battery is not inserted in its housing.
4.2 ASSEMBLY / DISASSEMBLY
OF THE BLOWER TUBE
1. Align the locking device (Fig.3.A)
with the protrusion (Fig. 3.B) on
the air outlet (Fig. 3.C).
2. Push the tube (Fig. 3.D) until it hooks
up firmly with the drive unit with a
"click" when it locks in place.
– To remove the tube, press the button
(Fig. 3.A) and then slide it out.
IMPORTANT Stop the machine and
always remove the battery (paragraph 7.2.2)
whenever the blower tube is removed.
EN - 8