ST AB 500 Li 48 Manual De Instrucciones página 145

PROBLEM
5. The machine gives off
smoke whilst working
6. Battery power
reserve is low
7. The battery charger
is not recharging
the battery
8. The LED indicator
(Fig. 8.E) remains
ON in steady mode
9. The LED indicator
(Fig. 8.E) remains ON
in flashing mode
If problems persist after implementing the solution, contact your Dealer.
14. ACCESSORIES ON REQUEST
14.1 ALTERNATIVE BATTERIES
Different capacity batteries are available to
suit specific operating requirements (Fig. 17).
The list of approved batteries for this machine
can be found in the "Technical Data" table.
14.2 BATTERY CHARGER
Device used to recharge the
(Fig. 18.A), standard (Fig. 18.B).
PROBABLE CAUSE
Damaged blower.
Severe working conditions
requiring greater
current absorption
Battery is insufficient for
operating requirements
Decrease in battery capacity
Battery is not correctly inserted
in the battery charger
Unsuitable environmental conditions
Dirty contacts
The battery charger is not energised
Faulty battery charger
Self-check failed
Battery communication error
Rotor blocked
Current overload
PCB overheated
battery: fast
Do not use the machine. Immediately
turn off the machine,
and contact a service centre.
Optimise operations (para. 7.2.1)
Use a second battery or extended
battery (para. 14.1)
Purchase a new battery
Check it is correctly inserted
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual)
Clean the contacts
Check it is plugged in and the
power socket is energised
Replace with an original spare part
If the problem persists, refer to the battery/
battery charger manual
Do not use the machine. Immediately
turn off the machine,
and contact a service centre.
Do not use the machine. Immediately
turn off the machine,
and contact a service centre.
Do not use the machine. Immediately
turn off the machine,
and contact a service centre.
Optimize machine usage.
Do not use the machine. Immediately
turn off the machine,
and contact a service centre.
14.3 BATTERY BACKPACK
The device is used to place the two batteries
and provides the electrical power required
for the operation of the machine.
It is provided with a cable used for the
connection to the machine (Fig. 1.I) and with
a selector (Fig. 7.B) to select one of the two
batteries (position "1" and "2") and "OFF".
14.4 BATTERY SIMULATOR
Battery simulator: device that, if
inserted in the machine housing, allows
the use of the battery backpack.
EN - 15
SOLUTION
remove the battery
(par. 7.2.3)
remove the battery
remove the battery
remove the battery
remove the battery