ST AB 500 Li 48 Manual De Instrucciones página 143

7.3 CLEANING THE MACHINE
AND THE ENGINE
To reduce fire hazards, keep the machine and,
in particular, the motor free of leaves, branches.
• Always clean the machine after use with a
damp cloth dipped in neutral detergent.
• Remove all traces of humidity using
a soft damp cloth. Humidity can
generate risks of electric shocks.
• Do not use aggressive detergents or solvents
to clean the plastic parts or hand grips.
• Do not spray water onto the motor
and electrical components and
prevent them from getting wet.
• Always keep the rotor clean and
free of dust and debris, by blowing
compressed air through the grille.
Do not spray water on the rotor.
• To avoid overheating and damage to the
motor or the battery, always keep the
cooling air vents clean and free of debris.
7.4 NUTS AND BOLTS
• Keep all nuts, bolts and screws tight to be sure
the equipment is in safe working condition.
• Check regularly that the
handles are fixed firmly.
8. STORAGE
IMPORTANT The safety regulations to
be followed for storage are described in
paragraph 2.4. Strictly comply with these
instructions to avoid serious risks or hazards.
8.1 STORING
When the machine is to be stored away:
1. remove the battery from its housing
and recharge it (para. 7.2.2);
2. allow the engine to cool before
storing in an enclosed space;
3. Clean (para. 7.3);
4. Make sure there are no loose or
damaged components. If necessary,
replace any damaged components and
tighten any screws and loose bolts or
contact the authorised service centre;
5. Store the machine:
– in a dry place;
– protected from inclement weather;
– in a place out of children's reach;
– making sure that keys or tools used
for maintenance are removed.
8.2 STORING THE BATTERY
The battery must be kept in a cool,
shaded place without humidity.
NOTE If unused for a long time,
recharge the battery every two months
to prolong its service life.
9. HANDLING AND TRANSPORT
Whenever the machine is to be
handled or transported you must:
– stop the machine (para. 6.5);
– remove the battery from its housing
and recharge it (para. 7.2.2);
– only hold the machine using the
handgrips and position the tubes so
that they do not case obstruction.
When transporting the machine
on a vehicle, always:
– remove the tubes;
– fasten the machine securely
with cables or chains;
– position it so that it does not
cause a hazard to anyone.
10. ASSISTANCE AND REPAIRS
This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can
be performed by the user. Any regulations
and maintenance operations not described
herein must be carried out by your Dealer
or Authorised Service Centre, which have
the necessary knowledge and equipment to
ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Any operations performed in unauthorised
centres or by unqualified persons will totally
invalidate the warranty and all obligations
and responsibilities of the manufacturer.
• Only Authorised Service Centres can carry
out guaranteed repairs and maintenance.
• The Authorised Service Centres only
use genuine spare parts. Genuine
spare parts and attachments have been
designed specifically for machines.
• Non-original parts and attachments are
not approved; use of non-original spare
parts and attachments will jeopardise
the safety of the machine and relieve the
Manufacturer from all obligations or liabilities.
EN - 13