Yamaha YSP-1100 Manual De Instrucciones página 65

• Select ANGLE TO WALL OR CORNER if this unit is
installed in the corner in your listening room. Adjust
the width and length of your listening room as well as
the distance of the listening position from this unit.
Listening position
from the unit
Room width
Room length
Choices for the room width and length:
2.0 m to 12.0 m
Choices for the listening position from this unit:
1.8 m to 9.0 m
Room width and length
Listening position from
the unit
Note
When you set the INSTALLED POSITION parameter in
MANUAL SETUP (see page 62), the parameters newly set for
the width and length of your listening room are automatically set
as the factory default value.
A)SETTING PARAMETERS 2/3
----- 5.4m ---
|
[ 5.4m ]
|
|
p
[ ]/[ ]:Up/Down [ ]/[ ]:Sel
[ENTER]:Return
A)SETTING PARAMETERS 3/3
[ 2.5m ]
[ ]/[ ]:Up/Down [ ]/[ ]:Sel
[ENTER]:Return
INSTALLED HEIGHT (Installed height of this unit)
Use to adjust the installed height of this unit.
Control range: 0.0 m to 3.0 m
Initial setting: 1.0 m
Floor
BEAM ADJUSTMENT (Beam adjustment)
Use to manually adjust the various beam settings. We
recommend that you select 5 beam as the beam mode
before adjusting these parameters.
Notes
• When INSTALLED POSITION is adjusted in MANUAL
SETUP (see page 62), the factory default value is automatically
set for this parameter except CENTER in FOCAL LENGTH
(see page 65).
• Depending on the beam mode settings (see pages 42 and 47),
some channel positions may not be available for selection. In
this case, "– –" is displayed. When using the stereo plus 3 beam
as the beam mode, set the surround left and right signals to be
output from the front left and right channels.
B)BEAM ADJUSTMENT
)HORIZONTAL ANGLE
b)VERTICAL ANGLE
c)BEAM TRAVEL LENGTH
d)FOCAL LENGTH
e)TREBLE GAIN
[ ]/[ ]:Up/Down
[ENTER]:Enter
MANUAL SETUP
0.0 m to 3.0 m
63
En