Dahle 104air Instrucciones página 26

The following conditions apply to the performance in terms of sheets listed under technical data:
Maximum number of sheets that are shredded in one pass under the following conditions: New cutting
rollers, oiled if needed, cold motor, power supply with nominal voltage and nominal frequency (230 V/
50 Hz; 120 V/60 Hz). Deviations may result in reduced sheet processing and increased operating noises.
The sheets are fed centrally and lengthwise at a 90 degree angle. The performance in terms of sheets can
also vary depending on the paper properties and input.
Subject to technical modifications!
Remove transport lock!
1. Apply the brakes! Prior to putting into operation for the first time, open the door and remove the
paper collection bin.
2. Remove the screws for the transport lock (paper collection bin compartment) from the base plate
underneath the shredding mechanism, re-fit paper collection bin and close door.
3. Each time the appliance is moved, the transport lock must be re-fitted.
1. Oil the shredding rollers using DAHLE document shredder oil (P5, P6 and P7 cross-cut shredding
only)!
2. Fill the oil tank with DAHLE document shredder oil!
General information
25
en