RFX Rower 2.0 Instrucciones De Montaje página 13

*NOTE*
We recommend that at least two people be present during assembly to prevent damage and injury.
1
Connect the rear spacer and rails with 4 screws type B, as shown in the diagram.
ALLEN WRENCH
(hex key)
4x screws B
Rear spacer
2
Place the seat on the rails as shown in the diagram.
Make sure that the larger, vertically mounted wheels (cargo wheels) lie on top of the aluminum rails
and that the smaller, horizontally mounted wheels (guide wheels) run between the rails.
Seat
23
3
Place the water tank between the rails, as shown in the diagram, and secure it with screws A.
4
Baseboard is attached between the guides - align the top two holes with the holes in the tank, then
attach the baseboard with screws A
Then tighten both locks with screws C, as shown in the diagram. If you have trouble aligning individ-
ual parts correctly, loosen all existing connections slightly and adjust the parts. Then firmly secure all
parts again.
2x screws C
4x screws A
4x screws A
2x lock
24