Publicidad
Idiomas disponibles
Idiomas disponibles
Loosen crossh-handles.
Turn the vacuum bar.
Tighten the cross-handles.
Inclination
If the vacuum result is unsatisfactory the in-
clination of the straight vacuum bar can be
modified.
Release the wing nuts.
Tilt the vacuum bar.
Tighten the wing nuts.
Turning on/off WDB
(BR 55/60 W only)
This function is required for operating the
spray suction attachment (accessory).
Turn the info button clockwise until
"WDB-Funktion=xxx" or "WDB-Func-
tion=xxx" is displayed.
Shortly press the info button.
Select "ON" or "OFF" by turning the info
button.
Press the info button to confirm the set
value.
30
English
Stand-by
If the operational break exceeds 30 min-
utes, the machine goes into stand-by
mode. To restart the machine, turn the key
switch briefly to "0" and then turn it again to
"1".
Shutting Down the Appliance
Close the regulatory button for setting
the water quantity.
Release driving lever.
Lift the cleaning head.
Briefly drive forward and suck of the re-
maining water.
Raise the vacuum bar.
The suction turbine will continue to run
for 5 more seconds to suck off residual
water from the vacuum bar and the vac-
uum hose.
Apply parking brake (optional). Press
the pedal downwards and move it to the
right to lock it.
Set the key switch at the operator con-
sole to "0" and remove the key.
Charge battery, if required.
Drain off dirt water
Warning
Please observe the local provisions regard-
ing the wastewater treatment.
Take the water discharge hose from the
support and lower above a suited col-
lection device.
Publicidad
