Eaton Tripp Lite Serie Manual Del Propietário página 12

Installation
5. Using an HDMI 2.0 cable (such as P569-XXX-CERT or
P568-XXX-2A Series cables), connect the remote receiver
unit's HDMI port to a monitor.
6. Turn on the power to your connected TVs/monitors. The
LOCAL (orange) LED will illuminate to indicate the local port
has been connected to a display.
7. Connect the external power supply to the splitter unit. Plug
it into an available wall outlet or a surge protector, power
distribution unit (PDU) or uninterruptible power supply
(UPS). The POWER (green) LED on the local splitter unit
will illuminate to indicate the unit is receiving power from
the external power supply. The POWER (green) LED on the
remote receiver unit's RJ45 port will illuminate to indicate
the unit is receiving power from the local transmitter unit
through PoC technology.
8. Turn on the power to the HDMI source. The RJ45 (orange)
LED will illuminate on both the local transmitter and remote
receiver units to indicate a signal is being received from the
source to display. The screen should now display on the
connected monitor(s).
12