Eaton Tripp Lite Serie Manual Del Propietário página 20

Installation
1. Make sure all equipment in the installation—such as TVs,
Blu-ray players and the transmitter—is powered OFF.
2. Using an HDMI 2.0 cable (such as P569-XXX-CERT or
P568-XXX-2A Series cables), connect the HDMI source to the
INPUT port on the local splitter unit.
3. Optional: For extended range, connect up to eight
B127A-010-H signal repeater units between splitter and each
receiver via Cat6 cabling.
4a. Optional for B127A-008-BH: Using an HDMI 2.0 cable
(such as P569-XXX-CERT or P568-XXX-2A Series cables),
connect a local monitor to the LOCALOUT port on the
B127A-008-BH local splitter unit. The LOCAL (orange) LED
will illuminate to indicate a display has been connected to
the local port.
or
4b. Optional for B127A-008-BH:
B127A-002-BH, B127A-004-BH or B127A-008-BH splitter
unit via the local HDMI port (sold separately). Repeat steps 4
and 5 below as necessary.
Note: The HDMI local display port only supports 4K/60Hz resolutions
and will not work properly with lesser resolutions.
4. Using Cat6 cable (such as N202-Series 24AWG Cat6 Cabling),
connect the RJ45 port on the local splitter unit to the RJ45
port on the remote receiver unit.
5. Using an HDMI 2.0 cable (such as P569-XXX-CERT or
P568-XXX-2A Series cables), connect the remote receiver
unit's HDMI port to a monitor.
20
Cascade an additional