Eaton Tripp Lite Serie Manual Del Propietário página 16

Installation
3. Optional: For extended range, connect up to four
B127A-010-H signal repeater units between splitter and
each receiver via Cat6 cabling.
4a. Optional for B127A-004-BHPH3: Using an HDMI 2.0 cable
(such as P569-XXX-CERT or P568-XXX-2A Series cables),
connect a local monitor to the LOCAL OUT port on the
B127A-004-BHPH3 local splitter unit. The LOCAL (orange)
LED will illuminate to indicate a display has been connected
to the local port.
Note: The HDMI local display port only supports 4K/60Hz resolutions
and will not work properly with lesser resolutions.
or
4b. Optional for B127A-004-BHPH3:
B127A-002-BH, B127A-004-BH or B127A-008-BH splitter
unit via the local HDMI port (sold separately). Repeat steps
4 and 5 below as necessary.
5. Using Cat6 cable (such as N202-Series 24 AWG Cat6
Cabling), connect the RJ45 port on the local splitter unit to
the RJ45 port on the remote receiver unit.
6. Using an HDMI 2.0 cable (such as P569-XXX-CERT or
P568-XXX-2A Series cables), connect the remote receiver
unit's HDMI port to a monitor.
7. Turn on the power to your connected TVs/monitors. The
LOCAL (orange) LED will illuminate to indicate the local port
has been connected to a display.
16
Cascade an additional