Adjusting The Handle Height; Operation; Starting The Machine; Burnishing - Tornado 98494 Manual De Usuario

Adjusting the Handle Height

Select the most comfortable handle height using the adjustment lever and lock into position.

Operation

Starting the Machine

WARNING – NEVER START THE MACHINE WITHOUT A PAD FITTED.

Turn the key operated switch to the ON position.

With the handle set at a comfortable working height and with both left and right hands on the handle,
press both interlock buttons with your thumb and squeeze both switch triggers to start the machine.

Once the machine has started, the interlock buttons can be released. The machine will operate with
either or both of the switch triggers held.

To stop the machine, release the switch triggers.

Normal movement of the machine is in a forward and backward position.

Burnishing


Fit pads suitable for the speed of the machine and the surface to be polished, as recommended by the
pad manufacturer.

Apply cleaning solution to the floor in accordance with the manufacturer's instructions.

Do not keep the machine rotating on one spot, as this could cause overheating and damage the floor
surface.

Cleaning Solutions

The choice of cleaning solution is at the discretion of the operator, when assessing the surface to be
cleaned. Cleaning solutions are only recommended for stubborn marks and should not be used as a general
cleaning aid.

When Cleaning is Finished


Switch OFF the machine, raise cleaning head and remove pad.

Wipe over the machine with a damp cloth.

Check battery life indicator and recharge as necessary.

Recharging the Batteries


IMPORTANT - Only recharge the battery when the battery life indicator is in the red zone (two lights
remaining).

Note that when only 1 RED LED is showing on the battery life indicator the internal controller will
disable the machine.

IMPORTANT – Opportunity top up charging will damage the batteries. This will cause run time to
fall and overall battery life will be affected. AVOID TOP UP CHARGING.

Take the battery charging lead supplied with the machine plug into the main supply, ensure that the
supply matches the rating plate.
It takes approximately 8 hours to fully charge the batteries.
Battery Charge Indicator Lights:

Two RED LEDs – The first indicates that the power is on and the second indicates that the initial bulk
charge is taking place.

YELLOW LED – indicates that the battery is now being charged on a constant voltage and that the
battery is about 80% charged.

GREEN LED – shows when the charger has switched over to float charge and that the battery is ready
for use. The battery should be left connected with a GREEN LED list until the battery is required for
use.

IMPORTANT – CHARGE ONLY IN A WELL-VENTILATED AREA.

THE CHARGER IS SET FOR GEL BATTERIES ONLY.

DO NOT OPERATE THE MACHINE WHEN CONNECTED TO THE MAIN ELECTRICAL
SUPPLY.
7