Publicidad
Safety
Signs, symbols and instructions placed on this product must never be covered or removed and must
remain present and clearly legible throughout the entire lifetime of the product. Immediately replace or
repair illegible or damaged signs, symbols and instructions. Contact your local dealer for instructions.
Any adverse event in relation to the device must be reported to your local dealer and the national com-
petent authority in a timely manner. The local dealer will forward information to manufacturer.
Caregiver
• Read the "User manual" carefully before
use and keep it for future reference.
Incorrect use of this product may cause
serious injury to the user
• This product contains small parts which
could present a choking hazard if removed
from their intended placing
• Users who have difficulties reading the
user guide can have someone read the
user guide aloud to understand how to use
the product.
• Always use the correct lifting techniques
and aids for this purpose
• Never leave the user unattended in this
product. Ensure permanent supervision
by an adult
• Repair/replacements must only be made
using new original R82 spare parts and
fittings and carried out in accordance
with the guidelines and service intervals
prescribed by the supplier
• If there is any doubt as to the continued
safe use of your R82 product or if any
parts should fail, stop using the product
immediately and contact your local dealer
as soon as possible
• Firmly grab hold and support the back of
the chair before adjusting it to prevent a
sudden recline.
• Transportation of the product whilst the
user is in it is not allowed. It is allowed
to use the product with the user safely
strapped in it for transfers over short
distances. Do not cross any obstacles
during transfer.
• The handles underneath the seat plate
can be operated by the user.
• Settings and adjustments to the product
or accessories are only to be made by
persons who have read the user guide.
• Ensure that moving parts does not
squeeze or trap body parts when adjusting
them
• Ensure that body parts are not trapped
in openings for mounting of supports/
accessories.
• Be aware of any MAX mark indications
before adjustment
Environment
• Observe the surface temperature on the
product, before placing an user in it. This
goes especially for users with insensitive
EN
skin as they cannot feel the heat. If the
surface temperature is above 41°C then
allow the product to cool before use
• Use this product on a level surface without
any obstacles. Be aware of reduced
maneuverability on slippery surfaces
• When using on inclines, please refer to
measurements
User
• Never carry the product with a user seated
in it
• If the user is close to the max. load
limit and/or has a lot of involuntary
movements, e.g. rocking, a larger size
with a higher max. load or a different R82
product should be considered
Product
• Wombat Solo comes with multiple
adjustment options. When adjusting the
product, take care that body parts are not
trapped in holes and openings intended
for adjustment.
• Carry out all positional adjustments on the
product and accessories and ensure that
all knobs, screws and buckles are securely
fastened before use. Keep all tools out of
the reach of children
• Lock the castors before placing the user in
the product
• Ensure the stability of the product is
maintained before placing the user in it
• For independent transfer ensure the
castors are locked sufficiently.
• When the footplate is close to the floor and
the castors, the castors may be unable to
swivel
• The footplate is for support only! The foot
support does not have a weight bearing
function
• Inspect the product and all of its
accessories and replace any worn out
parts before use
• Do not expose the gas spring to pressure
or high temperatures. DO NOT puncture
• Do not expose the piston rod to scratches
etc. It is important to use a cloth or the
like, if tools are used to adjust the gas
spring
• This product is tested for resistance to
ignition at level non-ignition in accordance
with EN 1021-1, EN 1021-2 and ISO
7176-16
42
etac.com
Publicidad
