Medion X50 SW Manual De Instrucciones página 204

 Select your WLAN network.
 In the next step, enter the password for your WLAN network (Fig. 3) and then tap
on NEXT.
If the WLAN network is not preselected, enter the network name manu-
ally. The password will be case-sensitive, so take care when typing it in.
The name entered must be identical to the network name in the WLAN
settings.
The next step is to set the robot vacuum to pairing mode.
 First set the robot vacuum and mop to factory settings.
 Place the robot vacuum and mop on the charging station that is connected to
the power supply and wait for the voice feedback LOADING (Fig. 4).
 Then click on the NEXT button.
 Press and hold the start/pause button
pliance for a few seconds until the voice feedback RESET WLAN occurs (Fig.5)
 Then click on the NEXT button.
Fig. 4
 Then open the cover flap of the dust compartment and check whether the
WLAN LED underneath the flap is flashing/pulsing (Fig. 6).
 Click on the CONFIRM THAT LED IS PULSATING button when the LED pulses
visibly.
and the home button
Fig. 5
DE
FR
NL
ES
IT
EN
on the ap-
Fig. 6
205