Changing The Tool - Fein AGWP10 Serie Instrucciones De Uso

OBJ_BUCH-0000000365-001.book Page 15 Monday, February 11, 2019 10:03 AM

Changing the tool

Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Mounting a tap with the 3-jaw chuck
(figure 6).
Degrease the output spindle and the inside
cone of the 3-jaw chuck before mounting.
Slide the 3-jaw chuck onto the drive spindle.
Mount the collet.
Insert the tap.
Tighten the 3-jaw chuck and the collet using
two open-end wrenches.
Fig. 6
Drive spindle
3-jaw chuck
1.
2.
Collet
3.
Tap
4.
en
15
Open-end wrench