Publicidad
Idiomas disponibles
Idiomas disponibles
2. Inspect the brake band, drive sprocket, and chain
catch for damage.
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
Inspect your tool for issues such as undue noise,
misalignment or binding of moving parts, breakage of
parts, or any other condition that may affect the tool
operation. Return the tool, battery pack, and charger
to a MILWAUKEE service facility for repair. After six
months to one year, depending on use, return the
tool, battery pack and charger to a MILWAUKEE
service facility for inspection.
If the tool does not start or operate at full power with
a fully charged battery pack, clean the contacts on
the battery pack. If the tool still does not work prop-
erly, return the tool, charger and battery pack, to a
MILWAUKEE service facility for repairs.
Sharpening the Saw Chain
Improper chain sharpening in-
WARNING
creases the potential of kickback.
Failure to replace or repair damaged chain can
cause serious injury.
The saw chain is very sharp, always wear pro-
tective gloves when performing maintenance to
the chain.
Top Plate
Rivet Hole
Heel
Gullet
Be careful to file all cutters to the specified angles and
to the same length, as fast cutting can be obtained
only when all cutters are uniform.
• Wear gloves for protection. Properly tension the
chain prior to sharpening. Refer to Chain Tension
section earlier in this manual. Do all of your filing at
the mid-point of the bar.
Left Hand Cutters
Right Hand Cutters
• Use a 5/32" diameter round file and holder.
• Keep the file level with the top plate of the tooth. Do
• Using light but firm pressure, stroke towards the
• Lift file away from the steel on each return stroke.
• Put a few firm strokes on every tooth. File all left
• CORRECT 25° - File holders are marked with guide
Cutting Corner
• LESS THAN 25° - For Cross Cutting.
Side Plate
• MORE THAN 25° - Feathered Edge Dulls Quickly.
Depth Gauge
Toe
• CORRECT - 80° Produced automatically if correct
• HOOK - "Grabs" and dulls quickly. Increases po-
• BACKWARD SLOPE - Needs too much feed pres-
12
not let the file dip or rock.
front corner of the tooth.
hand cutters in one direction. Then move to the other
side and file the right hand cutters in the opposite
direction. Occasionally remove filings from the file
with a wire brush.
Top Plate Filing Angle
CORRECT
Top Plate Filing Angle
25°
marks to align file properly to produce correct top
plate angle.
Side Plate Angle
CORRECT
Side Plate
Filing Angle
80°
diameter file is used in file holder.
tential of KICKBACK. Results from using a file with
diameter too small, or file held too low.
sure, causes excessive wear to bar and chain.
Results from using a file with diameter too large, or
file held too high.
INCORRECT
Top Plate Filing Angle
Less
More
than 25°
than 25°
INCORRECT
Side Plate Filing Angle
Backward
Hook
Slope
Publicidad
