Publicidad
Idiomas disponibles
Idiomas disponibles
2
1
20
19
1. Rear handle
2. Lock-off tab
3. Variable speed trigger
4. Chain brake cleanout
5. Hand guard/chain brake
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Before removing or inserting a battery, push the
hand guard/chain brake forward to ensure the
brake is locked.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always lock the trigger or remove
WARNING
the battery pack any time the tool
is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Replacing/Adjusting the
Saw Chain and Bar
Always remove battery pack before
WARNING
changing or removing accessories.
Chain is sharp. Always wear protective gloves
when handling the chain.
FUNCTIONAL DESCRIPTION
3
4
14
13
15
17
18
16
5
6
7
12
6. Direction of rotation
indicator
7. Guide bar nut
8. Saw chain
9. Guide bar
10. Adjustment tool
11. Guide bar cover
12. Locating pin
ASSEMBLY
Use Low Kickback Saw Chains - The rakers (depth
gauges) ahead of each cutter can minimize the force
of a kickback reaction by preventing the cutters from
digging in too deeply at the kickback zone. Only
use replacement chain that is equivalent to original
chain or has been certified as low kickback chain
per ANSI B175.1.
As saw chains are sharpened during their useful life,
they lose some of the low kickback qualities and extra
caution should be used.
1. Remove the battery pack.
2. Place the saw on a flat, firm surface.
3. Remove the drive cover
by removing the guide
bar nut using the adjust-
ment tool.
4. Loosen the chain by turn-
ing the chain tensioning
screw counterclockwise
with the adjustment tool.
5. Pull the guide bar off of the guide bar bolts and
unloop the chain from the drive hub. CAUTION!
Saw Chain is sharp.
6. Remove the chain from the guide bar groove.
CAUTION! Saw Chain is sharp. Inspect guide bar
for cracks or wear; replace if damaged.
7. Wrap the new or sharpened chain around the guide
bar in the direction indicated on the saw
When replacing dull chains with sharp chains it is
good practice to flip the guide bar from bottom to top.
6
10
8
9
13. Chain catch
14. Chain tension screw
15. Drive cover
16. Front handle
17. Oil cap
18. Oil reservoir
19. Brake band (internal)
20. Lanyard Loop
11
.
Publicidad
