3rd SOLUTION: KIT 10 (code 643890) con KIT 10 BIS (code 645690) - BOTH ROOMS
Note: THE PIPES ON THE HOT AIR OUTLETS MUST BE FITTED BEFORE APPLYING THE COVE-
RINGS AND PRIOR TO DISASSEMBLY OF THE UPPER CAST IRON SIDE FLANK. THE FIRST PART OF
THE FLEXIBLE PIPE MUST BE COMPLETELY "RELAXED" IN SUCH A WAY TO ELIMINATE CORRU-
GATION. IN THIS WAY, THE INTERNAL DIAMETER WILL BE SLIGHTLY ENLARGED TO FAVOUR
ENTRANCE.
- Define the position of the stove with respect to the walling (fig. a).
- Disassemble the upper part of the back (132) and remove the predrilled caps in correspondence with the hot air
outlet pipes (fig. b).
- Activate the hot air channelling control lever (13), removing the locking plates (133) (fig. b).
- Cut the flue cover to size (6) on the wall side (fig.c)
- Place the stove in its definite position.
- Extend the aluminium pipes (2-3) for hot air channelling, without connecting them to the stove outlets.
- Fit the medallions (5) on the aluminium pipes and the pipe covers (6) without locking them in (fig. c).
- Fit the aluminium pipes to the hot air outlets on the back of the stove (8) (fig. d).
- Replace the upper part of the back (132).
- Place the pipe covers (6) in the definite position and fasten them to the back of the stove with the supplied screws (7) (fig. d).
- Install the terminal outlets (4) and relative aluminium pipes (2-3), fastening them with the wall collars (9) and
the dowels with screws (10-11)(fig. d).
- Fasten the wall medallions (5) with silicone (fig d).
fig. a
fig. c
6
fig. d
8
1
Box
2
Ø 10 pipe
3
Ø 10 pipe
4
Smoke outlet end-piece
5
Wall medallion
6
Flue cover
7
Flue cover fastening screws
8
Pipe blocking clamp
9
Wall collar
10
Screws
11
Dowels
INSTALLATION
2
3
5
5
8
5
4
7
8
4
5
6
fig. b
2
3
4
8
5
10
9
3
2
6
5
6
n°
KIT 10
1
645740
1
-
1
162520
2
293430
2
644190
2
644140
8
168260
4
46160
2
-
4
-
4
-
51
132
133
13
132
5
1
5
7
6
6a
4
6
6a
8
9
9
10 11
10
9
4
8
KIT 10 BIS
643910
643900
-
293430
644190
644140
168260
46160
645750
8410
8520