ing, support the motorcycle with a side stand.
According to the road conditions, in order to
increase the comfort of the rider; the size of the
damping force can be adjusted through the adjust-
ment nut 1 at the lower end of the shock absorber:
the adjustment nut is rotated up or down by hand,
and the damping force of the shock absorber will
also become larger or smaller; thereby changing the
slow or fast rebound of the shock absorber. The
damping force adjustment nut will make a "click"
sound during adjustment. If there is no sound, it
means that the adjustment limit has been reached,
please do not continue to adjust in this direction.
In addition, there are two adjustment nuts 2 and 3 on
the other end of the shock absorber spring. After using
the shock absorber adjuster and sleeve 4, turn the
adjustment nuts 2 and 3 up or down to change the
preload on the shock absorber spring, thereby chang-
ing the damping problem of hard and soft vibrators.
Automatic stopping in case of rollover
This motorcycle has the function of automatic stopping
in case of rollover When the motorcycle rolls over or
leans to a certain angle, the engine will automatically
stop, to prevent the danger caused thereby.
Rear view mirror adjustment
The angle of rear view mirror
can be adjusted by rotating
rear view mirror frame 1 and
mirror lever 2. Properly adjust
the rear view mirror frame and
mirror lever properly until you
can clearly see the situations behind.
Seat cushion assembly and disassembly
Insert the key into the key hole
1 on the lower left side of seat
cushion, rotate the key clock-
wise, lift the seat cushion slightly
and push it forward to remove
the seat cushion.
Remove the fixing screws 2 on
the connecting plate of the rear cover, lift the connect-
ing plate of the rear cover slightly and push it back to
remove the connecting plate of the rear cover.
After removing the rear tail cover connecting plate,
remove the fixing screw 3 of the driver's seat cush-
ion to remove the driver's seat cushion.
Conversely, the seat cushion can be replaced.
17
2
1
3