Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY STEP 1
For Sliding and Swinging Gates ONLY
Assemble the T-Rail and
Attach the Cable Pulley Bracket
To avoid installation difficulties, do
not run the garage door opener until
instructed to do so.
1. Align the four T-rail sections on a flat
surface exactly as shown. Center
sections are interchangeable. Front
and back sections are also
interchangeable for ease of
assembly.
2. Connect the center section and the
1/4" lock nuts to the end sections from
the same side, as shown.
NOTE: If T-rail is not assembled exactly as shown,
trolley will not travel smoothly along length of rail
or it will hit against nuts.
3. Insert the carriage bolts from the opposite side of
the end sections. Tighten the nuts. When
assembled, T-rail has a front-to-back position as
shown.
4. Position the cable pulley bracket on the front end
of the T-rail as shown. Fasten securely with the
hardware provided.
NOTE: When tightening the bolts be sure to keep
bracket parallel to the rail. Otherwise, the rail may
bow when the opener is operated.
Brace
Rail
(End Section)
Rail connects to
opener at this end.
HARDWARE
SHOWN ACTUAL SIZE
Hex Bolt
5/16"-18x7/8"
Square Carriage
Bolt Hole
1/4" Lock Nut
Carriage Bolt
1/4"-20x1/2"
Rail
(Center Section)
10
Carriage Bolts
Lock Nut
1/4"-20x1/2"
1/4"-20
Nut
Lock Washer
5/16"-18
5/16"
Cable pulley bracket
attaches to this
end of rail.
AWAY FROM
OPENER
Rail
(End Section)
Hex Bolts
5/16"-18x7/8"
Lock Washer
5/16"
Nut
5/16"
Cable Pulley
Bracket
Publicidad
