Maintenance and Care
Battery retaining belt
Battery retaining belt
Negative
Negative
terminal screw
terminal screw
6. Clean and polish the positive and negative terminals with a
wire brush or sandpaper.
7. After cleaning, assemble the battery and the driver's seat
cushion according to the above steps.
48
Danger
and the battery itself will be damaged. The red line must be
connected to the positive terminal (+) and the black line must be
connected to the negative terminal (-).
• Be sure to turn off the power switch (key) when checking or
replacing the battery.
• The red harness is connected to the positive pole and the black
Positive
Positive
harness is connected to the negative pole.
end screw
end screw
Seek immediate medical attention if any of the
following conditions occur:
● Electrolyte splashes into eyes
Solution: Wash your eyes repeatedly with clean, cold water
for at least 15 minutes.
● Electrolyte splashes on skin
Solution: Remove contaminated clothing and wash skin
immediately with clean, cold water.
● Electrolyte enters the mouth
Solution: Rinse your mouth repeatedly with clean cold water.
Do not swallow.
• Make sure that the battery leads are connected
correctly when it is re-installed. If the battery
wires are connected reversely, the circuit system