QJMOTOR SRK 800 RR 2023 Manual Del Usuario página 64

Maintenance and Care
4.11.4. Tread depth inspection
Check the tread wear indicator. If the tire is worn to the
indicator mark, replace the tire immediately.
Or T. W. I.
Wear indication
position mark
• The use of tires with excessive wear or insufficient
Danger tire pressure can cause traffic accidents, resulting
in injury or even death.
• After replacing the new tire, you should go to the
designated repair shop to re-calibrate the dynamic balance.
58
4.12. Side stand
The vehicle is equipped with the function of side stand flameout
switch. When the engine is in neutral gear, the engine can start
and run normally. If the vehicle is in a gear other than neutral, the
engine cannot be started or will stall during operation when the
side stand is lowered.
1. Check whether the side stand can be retracted and put down
freely. Clean and lubricate the area of the rotating shaft if there
is an abnormal sound or sticking during the operation of the
side stand.
2. Check whether the side stand spring is damaged or loses its
elastic performance.
3. Sit on the motorcycle, turn on the power supply of the vehicle,
and withdraw the side stand.
4. Start the engine, shift the engine to the first gear, and then fully
lower the side stand. When you put down the side stand, the
engine should stop running immediately. If the engine does
not stop running, please send it to the designated repair shop
for repair and inspection.
Lay
down
Retract