Publicidad
Step 4
å
Turn the ENDS (A and B), UPRIGHTS (D and E), and BACKS (F) over.
å
Turn twelve BLACK 9/16" FLAT HEAD SCREWS (32S) into the ENDS (A and B),
UPRIGHTS (D and E), and BACKS (F) until the shoulders of the SCREWS rest on the
surfaces of the ENDS, UPRIGHTS, and BACKS.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the MOLDINGS (I) onto the ENDS (A and B) and UPRIGHTS (D and E). Slide the
MOLDINGS (K) onto the BACKS (F). Line up the grooves in the MOLDINGS over the
heads of the SCREWS in the ENDS, UPRIGHTS, and BACKS.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
The MOLDINGS should be centered over the ENDS, UPRIGHTS, and BACKS.
F
K
I
Page 10
K
F
D
E
B
I
BLACK 9/16" FLAT HEAD SCREW
(12 used in this step)
I
A
Apply pressure with your hands as you
guide the MOLDINGS over the SCREWS
and onto the ENDS, UPRIGHTS, and BACKS.
428728
32S
Shoulder
I
Shoulder
www.sauder.com/service
Publicidad
