Publicidad
Step 32
1
D28
W
Groove
å
Insert the LARGE DRAWER SIDES (D28 and D29)
at an angle into the slot at each end of the LARGE
DRAWER FRONT (W).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
å
Fasten the LARGE DRAWER BACK (D78) to the LARGE DRAWER SIDES (D28
and D29). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the LARGE DRAWER BOTTOM (D707) inserts into the groove
of the LARGE DRAWER BACK (D78).
Page 38
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D29
D78
D28
D707
2
D28
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the LARGE DRAWER BOTTOM (D707) into the
grooves in the LARGE DRAWER SIDES (D28 and D29)
and LARGE DRAWER FRONT (W).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D29
428728
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n fi
n i s h
s u r
e d
f a c
e
D707
D29
W
30S
(4 used in this step)
www.sauder.com/service
9
Publicidad
