Publicidad
Step 12
å
Separate the EXTENSION SLIDES (40NC) from the EXTENSION RAILS (40NA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten four EXTENSION RAILS (40NA) to the LEFT END (B) and LEFT UPRIGHT (E). Use eight GOLD 5/16" FLAT HEAD
SCREWS (3S) through holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END and UPRIGHT. Turn a
SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the SMALL DRAWERS.
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
2
1
Open end
Page 18
40NC
Push the black lever in and pull the SLIDE from the RAIL.
3S
4
3
4
3
2
1
B
1
2
3
2
4
3
4
E
428728
7
40NA
Open end
1
4
3
www.sauder.com/service
Publicidad
