Publicidad
Step 11
å
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (40MA) to the LEFT END (B) and LEFT UPRIGHT (E). Use four GOLD 5/16" FLAT HEAD
SCREWS (3S) through holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END and UPRIGHT. Turn a
SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the LARGE DRAWERS.
40MC
Push the black lever in and pull the SLIDE from the RAIL.
Edge with
TWIST-LOCK®
FASTENERS
P
Open end
www.sauder.com/service
4
B
3
2
1
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
428728
40MA
H
2
E
3
4
3S
7
Open end
1
Page 17
Publicidad
