Publicidad
Step 30
å
Before fastening the DOOR to your unit, be sure the mounting screw is against the
stops as shown in the right diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
å
Fasten the DOOR (BB) to the RIGHT END (A) as shown in the lower diagram.
Use the screws in the HINGES. You should start each SCREW a few turns before
completely tightening any of them.
å
Fasten a KNOB SET (136K) to the DOOR (BB). Use a BLACK 1-1/8"
MACHINE SCREW (21S).
å
Push the DOOR STOP (4I) into the RIGHT UPRIGHT (D).
å
See the next step for DOOR adjustments.
Page 36
A
D
428728
17
Stop
Mounting
screw
Hinge
4I
136K
BB
21S
BLACK 1-1/8" MACHINE SCREW
(1 used for the KNOB SET)
www.sauder.com/service
Publicidad
