Heiniger TAURO Instrucciones De Manejo Originales página 25

6 Operation
WARNING!
Incorrect operation may cause damage on persons or objects. Therefore:
y Do all the steps of operation according to the indications in this instruction manual.
6.1 Initial start-up
6.1.1 Requirements for the charging location
y Observe all technical data according to the operating conditions (3 Technical data).
y Power outlets in the outer area must be equipped with a residual current circuit breaker (FI).
y The workplace must dispose of sufficient illumination and ventilation.
y The charging location must be out of the reach of children.
The LEDs light up blue during the charging process. Once the charging process is complete, the
LEDs light up blue continuously. The device is ready for operation.
6.1.2 Attaching the clipping blade
Fig. 4
NOTE!
To ensure proper operation, make sure that the clipping blades (1) are correctly fitted
and the blades are aligned.
6.1.3 Setting the adjustment lever
1
Fig. 5
Translation of the original instructions / Hair clippers
1. Align the lower blade with the upper blade.
2. Tighten both screws (2).
1
2
Set the adjustment lever (1) according to the desired
X
cutting height as follows:
y Adjustment lever up - minimum cutting length
y Adjustment lever downwards - maximum cutting length
11