Descargar Imprimir esta página

Heiniger TAURO Instrucciones De Manejo Originales página 26

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 58
6.2
Activities during operation
6.2.1
Changing the clipping blade
Fig. 6
NOTE!
Only work with sharp clipping blades, replace blunt or defective blades without teeth.
The correct resharpening of clipping blades is only to be done by special machines or
by a specialist. In that case, contact your service centre.
6.2.2
Lubrication
A thin layer of lubricating oil between the upper and lower blades is essential for a good clipping
result and to increase the service life of the clipper and the clipper blade (Fig. 7).
CAUTION!
Insufficient lubrication of the clipping blade leads to overheating and a reduced service
life of the clipper and blade, as well as a reduction in battery life. Therefore:
Lubricate the blades sufficiently when clipping (at least every 15 minutes) to prevent them
X
from becoming dry (Fig. 7).
Only use the lubricants prescribed by the manufacturer.
X
NOTE!
Always oil the clipping blade with the special oil supplied or a kerosene oil of the
ISO VG 15 specification.
The provided oil is non-toxic and produces no irritation on contact with the skin or
the mucous membranes. This paraffin oil degrades to some 20% after 21 days
(CEL-L-33-T-82).
Fig. 7
CAUTION!
Remove all the leaking, used up or excessive grease from all the lubrication points, and
it is to be disposed in accordance with the local regulations.
12
1. Slide the on/off switch (Fig. 2/1) to position "0".
2. Unscrew both screws (2).
1
3. Remove the clipping blade (1).
4. Fitting the clipping blades see chapter 6.1.2.
2
The blades must be oiled before, during and after every
use. When the blades of the clipper leave stripes, oil may
be required. Place a few drops of oil ahead and laterally on
the clipper blades (see arrows). Wipe off the excessive oil
with a smooth, dry cloth. Lubrication sprays do not have
sufficient oil for a good lubrication, but serve for cooling the
clipping blades. Immediately change damaged or crenated
blades to avoid injuries.
Translation of the original instructions / Hair clippers

Publicidad

loading

Este manual también es adecuado para:

710-320710-322710-323