Daikin FXFQ07TVJU Manual Del Operador página 7

3. Remove the suction grille.
Open the suction grille 45° and lift it.
Then, unhook it from the three hooks.
4. Take out the air filter.
Refer to clause 2 for HOW TO CLEAN THE AIR FILTER.
(Page 2)
5. Clean the suction grille.
Wash the suction grille with neutral detergent using a soft
brush and then shake off water.
When the suction grille is extremely contaminated:
• Spray the detergent for a ventilating fans and ranges
directly to the suction grille, and keep it under that con-
dition for about 10 minutes.
After that, carefully wash the suction grille with water.
NOTE
• Do not wash the suction grille with water of 122°F
(50°C) or higher.
It may cause discoloration and deformation.
• When drying the suction grille, do not heat it with fire. It
may cause burning.
6. Attach the air filter.
Refer to clause 4 for HOW TO CLEAN THE AIR FILTER.
(Page 2)
7. Attach the suction grille.
Attach the suction grille in the reverse order mentioned in
the clause 3.
8. Attach the straps of the suction grille.
Attach the straps in the reverse order mentioned in the
clause 2.
9. Close the suction grille.
Refer to clause 5 for HOW TO CLEAN THE AIR FILTER.
(Page 2)
HOW TO CLEAN AIR OUTLET, SUCTION GRILLE,
THE EXTERIOR AND REMOTE CONTROLLER
• Wipe them with a dry soft cloth.
• When the stain cannot be wiped off, dip the cloth in a neu-
tral detergent diluted with water and twist the cloth.
After wiping off stain with this cloth, wipe them with a dry
cloth.
3P338599-12A English
Place to hook
Hook
Detergent
NOTE
• Do not use substance such as gasoline, benzine, thin-
ner, polish i ng powder and liquid insecticide sold in the
market.
It may cause discoloration and deformation.
• Do not wash them with water of 122°F (50°C) or higher.
It may cause discolorization and deformation.
• Be careful not to damage the sensor surface.
The sensors, if damaged, may not provide correct
sensing performance.
3