PNI P18UV Manual Del Usuario página 20

Manual programming (Channel memory)
Frequently used frequencies can be stored so that they can be
used whenever needed.
250 memories are available. Each memory can store the
following informa�on: transmission and recep�on frequency,
transmission power, bandwidth, ANI/PTT-ID se�ngs,
alphanumeric iden�fier (6 characters) of the channel or channel
name.
Frequency mode vs. channel mode
Press F+3 to switch between frequency mode and channel
mode. These two modes have different func�ons and are o�en
confused.
Frequency Mode (VFO): This is used for temporary frequency
assignment, such as a test frequency or quick field programming.
Channel mode (MR): used to select pre-programmed channels.
Example no. 1
Programming a CTCSS tone repeater channel offset
Save on channel 10:
RX = 432.55000 MHz
TX = 437.55000 MHz (+ 5) Offset Tone TX CTCSS 123.0
20