Diagnostics And Protective Features; Trip Codes - Control Techniques Commander SE11200025 Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

8

Diagnostics and Protective Features

Do not attempt to carry out internal repairs. Return a faulty drive to the supplier
for repair.
WARNING
The following protective features are incorporated within the Commander SE drive.
They are placed in order of Trip number which is the figure that is read back through the
serial comms.
8.1

Trip codes

When a trip condition occurs, the left hand display will show the legend
right hand display flashes one of the trip codes given in Table 8.1.
Trip Code
Trip
Number
UU
1
DC link under voltage
OU
2
DC link over voltage
OI.AC**
3
AC instantaneous over current trip
OI.br**
4
Overcurrent on braking IGBT
Et
6
External trip
O.SP
7
Over speed
tunE
18
Auto-tune failure
It.br
19
Ixt on braking resistor
It.AC
20
Motor overload on current x time
Oht1
21
Overheat
Oht2†
22
Overheat (heatsink thermistor)
th
24
Over temperature (Motor thermistor)
O.Ld1*
26
+24V or digital output overload
cL
28
Current loop loss on terminal 5
SCL
User serial communications
30
watchdog failure
Commander SE User Guide
Issue Number 9
Condition
Low AC supply voltage
Low DC link voltage when supplied by external
DC power supply
Excessive inertia in the machine during
deceleration
Deceleration rate set too fast for inertia of
machine
Insufficient ramp times
Phase to phase or phase to earth short-circuit at
the drive output
Drive requires autotuning to motor
Motor or motor connections changed, re-
autotune drive to motor (see parameter 38)
Excessive current in braking resistor
Braking resistor value too small
(Does not apply to Size 1 units)
External trip terminal opened (when
programmed)
Excessive motor speed (typically caused by the
mechanical load driving the motor)
Motor loaded or no motor connected
Excessive braking resistor energy
(Does not apply to Size 1 units)
Too much mechanical load
High impedance phase to phase or phase to
earth short circuit at drive output
Drive requires autotuning to motor
Motor or motor connections changed, re-
autotune drive to motor (see parameter 38)
Overheat thermal model
Temperature exceeds 95°C (203°F)
Excessive motor temperature
Excessive load or short circuit on +24V output
Input current less than 3mA when 4-20 or 20-4
modes used
Failure of serial communications between drive
and master
www.controltechniques.com
tr
whilst the
Possible Cause
71

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido