EINHELL GE-CM 18/30 Li Manual De Instrucciones Original página 35

be caught up or catapulted away by the ma-
chine.
c) Before using the scythe, visually inspect it
to ensure that the blade, mounting bolts and
the entire cutting apparatus are in good wor-
king order (i.e. not worn out or damaged). To
prevent any imbalance, replace worn out or
damaged blades and mounting bolts as a set
only (if applicable).
d) Remember that if the machine has several
cutting tools, the movement of one cutting
tool may result in the other cutting tools star-
ting to rotate.
Handling
a) Only mow in broad daylight or in well-lit condi-
tions.
b) Do not use the machine on wet grass.
c) Always maintain good footing on inclines.
d) Only operate the machine at a walking pace.
e) Always mow across hills i.e. never straight up
or straight down.
f) Be particularly careful when you change di-
rection on a slope.
g) Do not mow on overly steep inclines.
h) Always be extra careful when turning the mo-
wer around and when pulling it towards you.
i) Switch the mower off , pull the plug and wait
until the cutters have reached a complete
standstill if you need to tip the mower over,
transport it over surfaces other than grass
and if the mower has to be moved from and to
the area you wish to mow.
j) Never use the lawn mower if any guards or
safety grilles are damaged or if any attached
guards such as defl ectors or grass catching
devices are missing.
k) Use the ON/OFF switch carefully as descri-
bed in the manufacturer's instructions. Make
sure that your feet are far enough away from
the mower blade!
l) The lawn mower should not be tilted when the
motor is switch on unless it has to be raised
for starting purposes. In this case, tilt it as little
as absolutely necessary and only raise the
side opposite to that of the user.
m) Do not switch on the mower if you are positi-
oned in front of the chute.
n) Never move your hands or feet toward or un-
der any rotating parts. Keep clear of the chute
opening at all times.
o) Never lift or carry a lawn mower with the engi-
ne running.
p) Switch off the motor and pull the power plug:
Anl_SA_GE_CM_18_30_Li.indb 35 Anl_SA_GE_CM_18_30_Li.indb 35
GB
Make sure that all moving parts have reached
a complete standstill.
- whenever you leave the lawn mower unat-
tended.
- before you dislodge any blockages or clogs
in the chute.
- before carrying out any checks, cleaning,
maintenance or other work on the lawn mo-
wer.
- if you have struck a foreign object. Examine
the mower for signs of damage and carry out
any necessary repairs before restarting and
continuing to work with the mower. If the lawn
mower begins to experience exceptionally
strong vibrations, immediately switch it off
and check it.
- search for damage;
- repair the damaged parts as required;
- make sure that all nuts, bolts and screws are
fastened securely.
q) Switch off the mower and pull the plug whe-
never you leave the mower.
Maintenance and storage
a) Make sure that all nuts, bolts and screws are
tightened securely and that the machine is in
safe working condition.
b) Allow the mower to cool before you put it into
an enclosed area.
c) To avoid the risk of fi re, keep the motor
housing and ventilation slots clear of grass,
leaves, oil and grease.
d) Routinely check the grass basket for signs of
wear and impaired functionality.
e) For your own safety, have worn or damaged
parts replaced without delay.
f) Take care not to jam your fi ngers between
moving blades and stationary parts of the
equipment while you are adjusting the equip-
ment.
g) While you are carrying out maintenance work
on the blades, remember that the blades can
still be moved even if the power source has
been switched off .
h) For safety reasons, replace worn or damaged
parts. Use only original spare parts and origi-
nal accessories.
Using and handling the cordless tool
a) Only charge the batteries in chargers that
are recommended by the manufacturer.
A charger that is designed for a certain type
of battery may pose a fi re risk if it is used with
other types of battery.
b) Use only the correct batteries in the elec-
- 35 -
28.02.2024 10:52:52 28.02.2024 10:52:52