EINHELL GE-CM 18/30 Li Manual De Instrucciones Original página 43

be cleaned and lubricated.
•
Keeping your lawn mower in good condition
not only ensures a long lifespan and high per-
formance, but also enables the equipment to
thoroughly cut your grass with minimal effort.
•
The blade is subjected to more wear and
tear than any other component. Therefore,
routinely check the condition of the blade
and make sure that it is tightly fastened. If the
blade is completely worn out, it must be im-
mediately replaced or ground sharp again. An
excessively vibrating mower means that the
blade is not properly balanced or has become
deformed from striking an object. In this case,
the blade must be repaired or replaced.
•
There are no parts inside the equipment
which require additional maintenance.
7.3 Replacing the blade
Remove the rechargeable battery/batteries. For
safety reasons, we recommend having the blade
replaced by an authorized professional. Impor-
tant! Wear work gloves! Only replace the blade
with a genuine Einhell replacement blade, as this
will ensure top performance and safety under all
conditions.
Carry out the following steps to change the blade:
1. Undo the fastening screw (see Fig. 11).
2. Remove the blade and replace with a new
one.
3. When fi tting the blade, make sure it is ins-
talled in the right direction. The blade's air va-
nes must project into the motor compartment
(see Fig. 11). The dome mounts provided on
the equipment must be aligned with the punch
holes provided in the blade (see Fig. 12).
4. Then retighten the fastening screw with a
wrench. The tightening torque should be ap-
prox. 25 Nm.
At the end of the season, perform a general ins-
pection of the lawn mower and remove any grass
and dirt which may have accumulated. At the start
of each season, ensure that you check the condi-
tion of the blade. If repairs are necessary, please
contact our customer service center. Use only
genuine spare parts.
7.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
Anl_SA_GE_CM_18_30_Li.indb 43 Anl_SA_GE_CM_18_30_Li.indb 43
GB
•
Identification number of the machine
•
Replacement part number of the part required
8. Storage and transport
Remove the rechargeable battery/batteries.
Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempera-
ture is between 10 and 40 °C. Store the machine
in its original packaging.
Transport
•
Fit the shipping protectors, if any.
•
For easier transport and/or storage, open the
wing nuts (Fig. 3b / Item 13) far enough to al-
low the push bars to be flipped together at this
point. Take care not to damage the cable and
the push bar tubes.
•
Protect the machine from damage and the
strong vibrations that can occur particularly
when transporting in vehicles.
•
Secure the machine against slipping and tip-
ping over.
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should be
taken to a suitable collection center for proper dis-
posal. If you do not know the whereabouts of such
a collection point, you should ask in your local
council offi ces.
- 43 -
28.02.2024 10:52:53 28.02.2024 10:52:53