Pando ORPAN Usuario, Manual De Instalación página 25

System E
HOODS WITH CARBON FILTER IN SEC TRAY
Carbon
filter
Aluminium
filter
5.4. MAINTENANCE AND CHANGING BULBS
DICHROIC LAMP
a) Make sure the device is disconnected from the electrical power supply.
b) Remove the lamp with the aid of a screwdriver (see diagram).
c) Replace the lamp with a similar one
(Ø36mm dichroic, max. 20W, 12 Volt, G4).
Lampara dicroica
SQUARE TWO-PIN BULB
a) Make sure the device is disconnected from the
electrical power supply.
b) Open the window up fully to an angle of 90º (see
diagram) by pressing where it says PUSH.
c) Replace the bulb with a similar one (TWO-PIN,
max. 20 W, 12 Volt, G4 fitting).
d) Close the window. If it does not close properly
repeat the operation described under point B).
CANDLE-TYPE LAMP
a) Make sure the device is disconnected from the power
supply.
b) Remove the protective screen
c) Replace the bulb with an identical one. Fitting
a brighter one may damage internal and external
components of the hood (maximum 28W - 220-240V AC).
d) Close the protective screen
EN
- 25 -