Instructions For Use And Handling Of Controls - Pando ORPAN Usuario, Manual De Instalación

4. INSTRUCTIONS FOR USE AND HANDLING OF CONTROLS

Read and save these instructions
IMPORTANT: It is advisable to switch on the hood a little before you start to cook and leave it running
for a while after you finish cooking in order to remove all fumes and smells from the kitchen and from
the flue system.
Your Extractor Hood should be fitted with one of the following control systems to operate it, the use
of which is explained below:
ELECTRONIC CONTROL PANELS
CONTROL PANEL A
A
A B C
A Pressing this button switches on and off the lights.
B Pressing this button reduces the motor speed. When the minimum speed is reached the
LED on the button flashes on and off.
C
Motor ON/OFF. Pressing this button switches on the motor at the last speed set before it
was switched off.
D Pressing this button increases the motor speed. When the maximum speed is reached the
LED on the button flashes on and off.
E Timer o Last time: Pressing this button runs the hood at full aspiration power for
approximately 5 minutes. Es aconsejable usarlo una vez acaba la cocción, con el fin de
evacuar el posible ambiente residual que pueda quedar en la cocina. Pasado el tiempo
indicado la campana se parará automáticamente.
01 2
A B C
B
D E
A
3 4
B
C
D
D E F
E
F
C
A B C
ON/OFF lights
Suction speed one / OFF
Suction speed two
Suction speed three
Suction speed four
The motor timer keeps the hood switched on
for 10 minutes and then stops.
D E
D E
EN
- 13 -