Remote Control - Pando ORPAN Usuario, Manual De Instalación

4.4.- REMOTE CONTROL:

(optional on certain models only; consult distributor)
Remote Control Pando.
User Configuration Manual
Radio control used for the
remote operation of ducted cooker hoods.
Technical data:
• Alkaline battery powered:
• Operating frequency:
• Combinations:
• Max. consumption:
• Operating temperature:
• Dimensions:
OPERATING DESCRIPTION:
The transmitter is equipped with 5 buttons for cooker hood
management, as specified below:
Motor ON (speed
Increase speed.
level 1) / OFF
command.
Light ON/OFF
command.
One fast key-press needed for to turn on/off the lights of the
hood. The 2 seconds' key-press needed for turn on/off the
lights of the models with the courtesy light.
INITIAL OPERATING CONDITION:
The radio control is supplied by the manufacturer with default
codes already stored.
OPERATING MODES:
Standard configuration:
The default configuration assumes all "cooker hood – radio
control" systems have the same transmission code. If two
"cooker hood – radio control" systems are installed in the same
room or in the immediate vicinity, each system may affect the
operation of the other, due to the fact they have the same code.
It will therefore be necessary to change the code of one of the
radio controls.
Generating a new transmission code:
The radio control is supplied by the manufacturer with default
codes stored. If you want to create a new set of codes, proceed
as follows:
BeFree S6/S Radio Control complies with the
specifications set out in the R&TTE Directive 99/5/EC
EN
- 18 -
press and hold the UP, STOP and DOWN buttons simultaneously
for 2 seconds. After the LEDs light up
press the UP and DOWN buttons within 5 seconds:
The LEDs will flash 3 times to indicate that the process is
complete.
12V mod.23A WARNING! This procedure deletes all previously-stored
codes.
433,92 Mhz
4096
"Learning" the new transmission code:
25 mA
After changing the transmission code on the radio control, the
-20º a 55ºC
cooker hood electronic control unit must be made to "learn"
120 x 45 x 15 mm
the new code as follows:
Press the main "Power Off" button on the cooker hood and
then restore power to the electronic control unit. Within the
next 15 seconds, press the Light button:
control unit is synchronised with the new code.
Emergency button: In the event that the radio control
does not work, use the emergency button to switch the
appliance off. After any necessary repairs have been
performed, reset the emergency button.
Reduce speed.
Re-establishment of the standard configuration:
ONLY FOR THE REMOTE CONTROL V.2.0
For to re-establish the standard configuration, follow this
10-minute
procedure:
timer.
press and hold for 2 seconds these buttons
together until the LEDs lights turn on.
The press the buttons (within 5 seconds).
The LEDs lights will flash 6 times to indicate
that the operation is complete.
ATTENTION: After the re-establishment of the standard
configuration, the new transmission code must be shared
with the electronic control unit of the hood, please, follow
the procedure of the "Sharing the new transmission code".
WARNING:
Any adjustments or modifications which have not been expressly
approved by the holder of the legal conformity certificate may
invalidate the user's rights relating to the operation of the device.
WARNING: The battery should be replaced every year to
guarantee the optimal range of the transmitter.
To replace the exhausted battery, take the plastic lid
off, remove the battery and replace it with a new one,
observing the correct battery polarities. Type 23AE 12V
alkaline battery.
Used batteries should be discarded in special collection
bins.
this will ensure the