Solter Aerotig 4320 DC Manual De Instrucciones página 39

P.20 -
P.21 3
P.22 50
P.23 10
P.24 350
P.25 -
P.26 -
P.27 -
P.28 7
P.29 65
P.30 -
P.31 30
P.32 25
P.33 -
P.34 50
P.35 3
P.36 Nor
P.37 -
P.38 -
P.39 -
P.40 -
P.41 -
P.42 -
SOLTER
SOLDADURA S.L.
Not available in this model.
Length of earth lead, in meters. Allows you to compensate the voltage reading.
Section of earth lead, in mm
Minimum amperage setting in remote MMA mode. See P.03
Maximum amperage setting in remote MMA mode. See P.03
Not available in this model.
Not available in this model.
Not available in this model.
Arc-force sensitivity for coated electrodes.
It allows adjustment of sensitivity to activate the arc-force mode. A high value delays
the activation of this feature. Lower values improve the transfer of material for alumi-
nium or stainless steel-coated electrodes.
Preheating amperage for TIG ignition. A high value facilitates ignition but can cause
the tungsten to stick to the work piece.
Not available in this model.
Current pulse in TIG DC ignition by HF.
Current pulse time for HF ignition, in milliseconds.
Not available in this model.
Bi-Level feature setting for pulsed arc TIG.
During welding, if you change from the primary to secondary button, an average am-
perage level corresponding to the percentage specified in this parameter is set. All
pulse levels change accordingly.
Circulation time of coolant after finishing a weld, in 10 second intervals.
Operation mode of the cooling unit.
It is recommended to have the automatic mode selected at all times.
Nor - Automatic mode (recommended).
For - Forced mode. This can be used for a short period of less than 2 minutes to faci-
litate the task of priming the coolant circuit.
dis - Disabled mode. Only use this mode if you are going to use an uncooled torch.
Remember to enable the automatic mode again when finish. DO NOT disable the co-
oler if you are using a cooled torch (this could damage the torch!).
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
Not available in this model.
. Allows you to compensate the voltage reading.
2
AEROTIG DC 38