Eaton TRIPP LITE Serie Manual Del Usuario página 10

1. Closure Assembly
1.3 Install the Branching Cable
1
Turn over the splice tray and remove the cable clamp from the tray
(Figure 1-14).
2
Strip the branching cable to a suitable length of ≥4 ft. (1.2 m) (Figure 1-15).
3
Cut the strength member of the cable from the stripped cable sheath 2.4 in.
(60 mm) to fix the cable (Figure 1-16).
10
04-065-93-47C0_revA.indb 10 04-065-93-47C0_revA.indb 10
Figure 1-14: Remove cable clamp
Figure 1-15: Strip the branching cable
Figure 1-16: Strength member
Bare fiber
Bare fiber protective sleeve
Strength member
1/31/2024 3:43:06 PM 1/31/2024 3:43:06 PM