BGS technic 9072 Manual De Instrucciones página 13

REMOVAL
Disconnect the electrical connections of the VVT
solenoids and remove the inlet and exhaust VVT
solenoid units from the timing belt cover.
Remove the engine under-shield and the right hand inner wing
shield to give access to the crankshaft pulley and the starter
motor. Remove the starter motor from the engine.
Remove the blanking plug for the crankshaft timing pin
position.
Note: When locating the blanking plug, be aware that it may
be obscured by the driveshaft.
Fit tool (3), ensuring that it is fully located in the engine
block.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed